Webb County Semi Truck HelpEspañolCall (956) 462-6935

Semi Truck Tire Blowout: What to Do

Short answer: hold the steering wheel firmly with both hands and stay off the brake while the truck slows down. Once you have control, brake gently, signal and get as far off the road as you safely can. Turn on your flashers, set your triangles within 10 minutes, and call for roadside tire service. Don't drive on the flat and don't try to change or inflate the tire yourself.

Stay clear of traffic while you wait, away from the travel lanes, not between the truck and passing vehicles.

Call (956) 462-6935

In the first seconds

Georgia's CDL manual, like other state CDL manuals, lists three steps for a tire failure:

  1. Hold the steering wheel firmly. A front tire failure can twist the wheel out of your hands. Keep both hands on it.
  2. Stay off the brake. Braking right after a tire fails can make you lose control. Unless you're about to hit something, let the truck slow down first. Then brake gently, pull off the road and stop.
  3. Check every tire once you're stopped. On duals, a failed tire may only be visible up close.

CDL manuals list the signs: a loud bang, a vibration, or a change in how the truck feels. Steering gets heavy when a front tire fails. A failed rear tire may only show up as a thump or heavy vibration, since duals usually keep the rear from fishtailing. Either way, the steps are the same.

Where to stop

  • As far onto the shoulder as you safely can, on level ground if possible.
  • Away from curves and hilltops where other drivers can't see you in time.
  • Off the ramp or bridge if the truck can roll a short distance safely at low speed. Don't drive far on a flat.

Set your warning triangles

Where to place warning triangles for a stopped truck Two road diagrams, not to scale. Top: on a divided highway or one-way road, all three triangles go behind the truck toward approaching traffic, at about 10 feet, 100 feet and 200 feet. Bottom: on a two-way road, one triangle about 10 feet from the truck on the traffic side toward oncoming traffic, one about 100 feet behind and one about 100 feet ahead. Turn on flashers right away and set triangles within 10 minutes. Divided highway or one-way road (like I-35) shoulder traffic →traffic → 10 ft100 ft200 ft Two-lane or undivided road ← oncomingtraffic → 10 ft100 ft100 ft Flashers on right away. Triangles out within 10 minutes.Distances from 49 CFR 392.22. Not to scale.
Hazard flashers on right away, triangles out within 10 minutes (49 CFR 392.22).

Federal rule 49 CFR 392.22 says to turn on the hazard flashers right away and set out warning devices as soon as possible, within 10 minutes.

  • On a divided highway like I-35: one about 10 feet behind the truck on the traffic side, one about 100 feet back and one about 200 feet back, all toward approaching traffic.
  • On a two-way road: one about 10 feet behind the truck on the traffic side, one about 100 feet behind it, and one about 100 feet ahead of it.
  • Near a curve or hilltop (within 500 feet): move the one on that side to between 100 and 500 feet from the truck.

Why not change it yourself

Truck wheels and tires hold a lot of energy when they're inflated. Federal workplace safety rules (OSHA 1910.177) require employers to train anyone who services large-vehicle rim wheels and to use a restraining cage or barrier when inflating, because a wheel can come apart under pressure. A roadside tire provider has the equipment. Wait for them.

Can the truck move on the other tires?

Federal rule 49 CFR 393.75 doesn't allow a truck to run on a flat tire or one with a leak you can hear, with ply or belts showing, with tread or sidewall separation, or with a cut down to the ply. A blown tire meets at least one of those. Have it replaced where the truck is, or ask the provider whether a short, slow move to a safer spot makes sense.

What to tell the provider

  1. Exact location and direction of travel.
  2. Which tire: steer, drive or trailer; left or right; inside or outside on a dual.
  3. The tire size from the sidewall of a matching tire (for example, 295/75R22.5).
  4. Whether the wheel, mud flap, fender, air lines or lights near it are damaged.
  5. Whether you're loaded, and what you're hauling.

After the tire is replaced

  • Have the other tire of the pair checked if it was a dual. It carried the load alone after the failure.
  • Ask the provider whether the lug nuts should be rechecked after the first miles.
  • Keep the receipt with the tire position and size for your maintenance records.
  • Check your tread depth on the rest of the tires. The federal minimum is 4/32 of an inch on steer tires and 2/32 on the others.

Blowout on the road right now?

Once the truck is stopped and the triangles are out, call. Know which tire it is and its size.

Call (956) 462-6935

Related: Semi truck tire repair · Roadside truck repair · All guides · Semi truck repair in Laredo

Sources

Last updated: November 21, 2026

Call (956) 462-6935
MenuClose